Installation Guide

GenStone products are designed to provide a realisc
look of stone, rock, or brick. Although installaon of
GenStone is much easier than tradional masonry
applicaons,proper installaon requires good planning
and preparaon. Each applicaon varies, therefore
we recommend you read this enre guide before
beginning your project.When calculang the amount
of GenStone needed for your project, remember that
RECOMMENDED TOOLS
OPTIONAL TOOLS
• Hand Saw
• Ulity Knife
• Tape Measure
• Caulking Gun for a 10 oz Tube
• Tapcon Screws
• Masonry Screw Driver Bits
• Drill
• Framing Square
• Level
• Sandpaper
• Marker
you will need addional pieces for unique cuts, such
as gables, end walls, or areas around windows. A
minimum of a 5% addional product is recommended
for mely compleon of your job. Keep in mind, your
le over product can be used in other areas of your
project to. It is also recommended that addional
panels be purchased and scrap pieces be kept in case a
repair is needed.
APPLYING TO CONCRETE
• Gloves
• Safety Goggles/Glasses
• Table Saw
• Compound Miter Saw
• Jig Saw
• Power Sander
• Rubber Mallet