Installation Guide
GenStone products are designed to provide a realisc
look of stone, rock, or brick. Although installaon of
GenStone is much easier than tradional masonry
applicaons,proper installaon requires good planning
and preparaon. Each applicaon varies, therefore
we recommend you read this enre guide before
beginning your project.When calculang the amount
of GenStone needed for your project, remember that
RECOMMENDED TOOLS
OPTIONAL TOOLS
• Hand Saw
• Ulity Knife
• Tape Measure
• Caulking Gun for a 10 oz Tube
• 6” x 1.25” Drywall Screws
• Screw Driver Bits
• Drill
• Framing Square
• Level
• Sandpaper
• Marker
you will need addional pieces for unique cuts, such
as gables, end walls, or areas around windows. A
minimum of a 5% addional product is recommended
for mely compleon of your job. Keep in mind, your
le over product can be used in other areas of your
project too. It is also recommended that addional
panels be purchased and scrap pieces be kept in case a
repair is needed.
APPLYING TO GYPSUM
BOARD
Interior Installaons
• Gloves
• Safety Goggles/Glasses
• Table Saw
• Compound Miter Saw
• Jig Saw
• Power Sander
• Rubber Mallet