Instruction Manual

P-LINK User’s Manual Revision 15.0 29
Gentec Electro – Optics, Inc. All rights reserved
*FAS
Turns the autoscale mode on.
“ACK\r\r\n”
Please note that you must type the exact number of characters or numerical values required.
Example: *AOB1.00E+01 has 8 characters/numerical values. Don’t put any space between
characters or numerical values.
7.2 P-LINK Error Messages
“\r\r\nE01\r\r\n”
Bad Command
“\r\r\nE02\r\r\n”
Energy Mode is not available
“\r\r\nE03\r\r\n“
N/A
“\r\r\nE04\r\r\n“
The selected wavelength correction factor is not valid
“\r\r\nE05\r\r\n”
The connector is not connected
“\r\r\nE06\r\r\n”
Attenuator not available