User Manual

Version 5.0
Ultra Series UP Instruction Manual Gentec Electro-Optics Inc. All rights reserved
8
a
Except 1350 – 1450 nm.
b
The calibrations at 2.1 to 2.5 µm and 10.6 µm are on special request only.
c
Nominal value, actual value depends on electrical noise in the measurement system.
d
Without anticipation. ± 5 µW with anticipation.
e
At 150 µW. 12 μW/°C for XLP12 with SOLO, 50 μW/°C for XLP12 with P-LINK.
Specifications subject to change without notice.
…12-…-3S-VP
XLP12-3S-VP
Effective Aperture Diameter
12 mm
Spectral Range
0.248 – 20 µm
Calibrated spectral range
0.248 – 2.5 µm
b
Power Noise Level
c, d
± 0.5 µW
Thermal Drift
e
12 µW/
o
C
Typical Rise time (0-95%)
30 s (3.0 s with anticipation)
Typical sensitivity
220 mV/W
Calibration Uncertainty
± 2.5 % @ 1.064µm
± 3.5 % @ 0.25-2.5µm
Linearity with Power
± 2 %
Repeatability (Precision)
± 0.5 %
Power Resolution
± 0.5 %
Max. Average Power
3 W
Max. Average Power (1 min)
(cooling : minimum 3 min)
3 W
Minimum Repetition Rate
7 Hz with Antipation
1 Hz without Anticipation
Max. Average Power Density
1 W CW
30 W/cm2 @1.064 μm
8 W/cm2 @0.532 μm
4 W/cm2 @0.355 μm
Pulsed Laser Damage Thresholds
1.064 µm, 7 ns, 10 Hz
532 nm, 7 ns, 10 Hz
355 nm, 7 ns, 10 Hz
Max. Energy Density
4 J/cm
2
3 J /cm
2
1 J /cm
2
Dimensions (H x W x D, in mm)
With isol. tube:
73 x 73 x 72
W/o isol. tube:
73 x 73 x 20
Weight
(head only, with isolation tube)
0.316 kg
Cooling
Heat sink
Recommended load Impedance
100 kΩ
Output Impedance
N. A.
Linearity vs beam dimension
± 0.7 %
PCB electrical supply
N. A.
Max output signal
N. A.