- Purifier HEPA Filtered Enclosures & Purifier Class I Filtered Enclosures User's Manual

Cha

ter 3: Gettin

Starte

0.36" of the front of the work surface. Mounting holes are

provided in the Labconco accessory work surfaces to secure the

enclosure.

Work Surface Specifications

The work surface should be smooth, rigid, and durable, such as a

chemical-resistant epoxy resin. The surface should be non-porous

and resistant to the biohazards, powders, solvents and chemicals

used in conjunction with the Purifier Filtered Enclosure. The work

surface should also contain a dished recessed area for containing

primary spills.

Work Surface and HEPA Filtered Enclosure Installation

1. Level the base cabinets and the work surface. Work

surface should be placed flush with the front of the base

cabinet as shown in Figure 3-1.

2. Position the work surface in its intended location and with

the front of the work surface towards you. (Rear mounting

holes are located close to the rear edge.)

3. Secure the work surface to the base cabinet with a

structural adhesive or silicone sealant.

4. Insert the supplied mounting screws in the four holes.

Allow a minimum of 1/8" clearance under the head of the

screw for positioning the enclosure.

5. Place the enclosure on the work surface and slide the rear

flange and front air foil flanges under the mounting screw

heads.

6. Tighten the four screws to complete the installation.