Product Manual

Table Of Contents

Page: 13 of 16

Secure GenTent Canopy over GenTent Frame

- Position GenTent canopy opening over frame. Be certain that the fueling door is

not on the same side as the generator exhaust (fig. 6-A).

- Slide GenTent canopy over the frame so that all four corners are generally equal

and level (fig. 6-A).

- Center GenTent canopy such that Vent Rod is centered under the top cap (fig. 6-

A).

Fig. 6-A (GenTent 10k and GenTent 20k)

- Slide one corner elastic over the corresponding

clamp telescoping rod and set it to sit under the

clamp body (fig. 6-B).

- Repeat on opposite corner, then on the

remaining two corners. Recheck and adjust

canopy if necessary.

- Adjust clamps left to right as necessary so that

Cover seams generally match the frame rods.

- Recheck clamps; they should be firmly in place

and may exhibit a slight upward lean.

Fig. 6-B