Product Manual

Table Of Contents

Page: 10 of 24

2. Assemble the Extender Arms

Each Angle Brace has a slotted receiver (female end) for the Extender Arm prongs (male

end) to insert into (Fig 2.1). Once installed the Extender Arms will give you a

platform to install your GenTent Frame Rods into.

Connecting the Extender to the Angle Brace

a. Align the Extender Arm prongs

with the slotted receiver of the

Angle Brace.

b. Push the Extender Arm straight

into the Angle Brace until the

pivot pins snap into place (Fig 2.1)

c. Repeat this process for all four

corners.

Finding the Right Position for the Extender Arms

You will use the Extender Arms to create a span large enough to create an offset

rectangle around your inverter (Fig 2.2) with a width of 23” to 25” by a length of 34” to

36”. The GenTent should be installed offset from center to ensure the exhaust is as

close to the edge of the Canopy as possible, this allows for the exhaust to escape

quickly and maintain the generators cooling profile.

d. Angle the Extender Arms on the exhaust side away from each other. If the distance

from the fourth hole to the fourth hole is less than 23”, then add an Extender

Arm to each side and re-measure.

e. Move to the opposite end from your exhaust and add Extender Arms evenly until

you can measure a length between 34” to 36”. (Fig 2.4 “B”)

Select holes that are closest to 23” – 25”

Fig. 2.2

Exhaust Side

Note

Install Extender Arms with the Frame Rods holes facing up.

Fig. 2.1