Product Manual

Table Of Contents

Page: 11 of 24

How to Add Additional Extender Arms

To install additional Extender Arms, align the Extender Arm prongs with the receiver slot

of the installed Extender and push the Extender Arm in until the pivot pins snap into

place.

Making Final Extender Arm Adjustments

f. Measure the width between the rod holes on the second set of Angle Braces to

ensure the distance is between 23” and 25” (Fig 2.4 “C”)

g. If the distance is less than needed, adjust each Extender Arm outward on the Angle

Brace by one position and repeat this measurement.

Note

Each Angle Brace has adjustment teeth with 5 different positions. This is to allow

the Extender Arms the ability to move into the desired location. For many inverters

you will start by moving the Extender arms out to their furthest positions away

from the inverter case.

Note

A maximum of three Extender Arms on any one corner will be used during normal

setup and operation.

Fig. 2.3