Product Manual

Table Of Contents

Page: 14 of 24

3. Install GenTent Frame

a. Orient the Center Connector with the

vent pin up and position the Center

Connector to match generator

alignment, short and long sides,

respectively. Unless you are installing in

parallel; see Page 18 “Installing the

GenTent with Parallel Units”.

b. Insert the first Frame Rod into the

Center Connector, ensuring it is seated

all the way into the Center Connector.

(Fig. 3.1) Always insert the Frame Rod into the Center Connector before

inserting it into the Extender Arms.

c. Insert the other end of the frame rod fully into the corresponding Extender

Arm hole at the pre-measured locations (Fig 3.2)

d. Install the Frame Rods into the Center Connector in a crisscross

pattern. Always be sure to grasp the free end of the frame rod

firmly. Then bend the free end towards the Extender Arm and

insert fully into the correct hole.

e. Repeat for remaining Frame Rods.

f. Check the Extender Arms; the Frame Rods should be fully seated into the

Frame Rod holes. (Fig. 3.2) The Extender Arms will exhibit a slight upward

lean; this is due to the force being applied to them by the fiberglass rods.

If any Extender Arm assemblies

exhibit twisting, move the

Extender Arm one position in the

direction of the twist on the Angle

Brace, or alternatively move the

entire Angle Brace in the direction

of the twist until the Extender

Arms straighten out.

Fig. 3.1

CAUTION

Always grasp frame rods & center connector firmly during installation to avoid the whipping

motion that can occur if a bent fiberglass rod is mistakenly released.

Fig. 3.2