Product Manual

Table Of Contents

Page: 15 of 24

4. Cover the GenTent

Grasping the GenTent by the center of the

top cap, open the GenTent Canopy and

place it onto the GenTent frame. Do not pull

the open corners of the top cap; these are

for ventilation.

b. Place the GenTent Canopy on the Frame

Rods. Center the top cap on the Center

Connector pin. (Fig 4.1) Ensure the GenTent

Canopy coverage is generally equal and

level.

c. Slide one corner elastic under the end of the

Extender Arm and set it behind the Frame

Rods. (closer to the generator than the Frame

Rods) (Fig. 4.2)

d. Repeat on opposite corners. Review and adjust

Canopy if necessary, to ensure it is level.

Install the Electrical Panel Apron

e. Along the bottom edge of the GenTent Canopy

is an over-flap. Flip up the over-flap from

corner to corner above the electrical outlets.

This will reveal a fastener strip. (Fig. 4.3)

f. Center the Electrical Panel Apron in front of the

generator electrical panel and press the apron

firmly onto the fastener strip. The Apron can

be adjusted to the left or right in order that it

stays a minimum four inches away from the

exhaust. Do not block the exhaust!

g. Flip the over-flap down and over the Electrical

Panel Apron. This will ensure water runs over

the front of the apron, keeping the electrical

outlets dry.

Fig. 4.1

Fig. 4.2

Fig. 4.1

WARNING

Never position the refueling door on the same side as the exhaust muffler.

Spilled gasoline can result in fire. Always use a funnel for refueling