Product Manual

Page: 5 of 24
Illustrations by Robert Ross, Fine Products, Inc. - All Rights Reserved - V20210601
1. Assemble and Install Strap Mount
Understanding the Mounting
Components
The Angle Braces and Extender Arms
work together with the Kevlar®
ratchet buckle (Fig 1.1) to create a
stable and strong mounting point for
the GenTent frame on your inverter
generator.
The Kevlar® Ratchet Strap (Fig 1.2) is
installed through the Angle Brace center and
is tightened to create the base of the
mounting assembly to your inverter case.
The Angle Braces (Fig 1.3) are held to the four
corners of your case along with the Gator
Grommets™ by the Kevlar® Ratchet Strap and
creates a firm mounting and adjustment point
for the Extender Arms.
The Gator Grommets™ (Fig1.4) are pressed onto
the pins of the Angle Brace to create a corner
mounting assembly. The grommets allow the
assembly to grip the generator case without
marring the surface. Each Gator Grommet™ has
two (2) thicknesses allowing for optimal fit on
various case shapes.
The Extender Arms will connect directly to
the corner Angle Brace. Additional Extender
Arms can be added to provide additional
support for the GenTent frame.
Center Slot
Ratchet handle
Release lever
Fig. 1.2
Fig.1.3
Fig. 1.1
Thin side
Thick side
Fig.1.5
Fig.1.3
Fig.1.4