Product Manual

Table Of Contents

Page: 6 of 24

Determine the Angle Brace Location and Grommet Setup

Determining the location of the Angle Braces means you must also

determine the best configuration of your Gator Grommets™. In this section

you will learn how to best install your Gator Grommets™ onto your Angle

Braces and where they will be installed once tightened via the Kevlar®

Ratchet Strap.

a. Hold an Angle Brace on a corner nearest to the electrical panel, slightly under the

electrical outlets (Fig 1.6) with the grommet pins up and down.

b. Identify the placement of your Angle Brace and determine the slope of the case for

each corner. The way in which it curves (or not) determines if the case has a

positive, negative or no slope. (Fig 1.7) You will need this information in the next

section.

c. If the Angle Braces are parallel to the exhaust pipe, lower the Angle Braces so that

they are below the exhaust pipe.

Install the Gator Grommets™

The Gator Grommets™ are used to keep the Angle Braces as level as possible on the

case and to give the mount assembly a tight grip against the case. Use the diagrams in

Figures 1.8, 1.9 and 1.10 to see how to install the Gator Grommets™ based on your

slope.

d. Once you know the slope of your generator case you will need to push the Gator

Grommets™ onto the Angle Brace in the correct configuration.

e. If you have a case that is straight up and down (Vertical case); install both Gator

Grommets™ so that the “thin” (fig 1.4) side will be facing the generator case. (fig

1.8)

Fig. 1.7

Installing on Generators with High Exhausts

Some Inverters have an exhaust above the height of the electrical panel. In

this case, you must install the Angle Braces at different heights on the

exhaust side as compared to the electrical panel side, to ensure the exhaust

is venting out under the canopy. The result will be a sloped GenTent canopy.

Scan the QR code to learn more

Fig. 1.6