Product Manual

Table Of Contents

Page: 8 of 24

Threading the Kevlar® Strap Through the Angle Braces

The Kevlar® Ratchet Strap is what secures the four Angle Braces to the case of your

generator. It is threaded through and behind the Angle Brace center (Fig 1.11) circling

around the generator to feed into Ratchet Buckle for tightening.

h. Unwind your Kevlar® Strap, take the loose end and feed it through each Angle

Brace, ensuring to stay under the strap guides (Fig 1.11) and behind the center

section (Fig 1.11). While feeding the strap through each of the Angle Braces avoid

twisting the strap and be sure the grommets are facing toward the case.

Strap the Assembly to the Case

With the Kevlar® Strap fed through the four Angle

Braces you are now going to tighten the strap to

hold them in place.

i. Loosely place the four Angle Braces next to the

four corners of the generator with the strap

running through them and the Gator Grommet™

facing the case.

j. With the Ratchet open, feed the

loose end of the strap through the

center slot so that the strap is

coming towards the top of the

ratchet handle (Fig 1.12). Do this

until all the excess strap is through

the ratchet center. Ensure that the strap has not twisted.

k. Pull the Kevlar® Strap slack tight through the Ratchet Buckle center.

Maintaining tension on the Kevlar® Strap, position the Angle Braces

into the desired positions on the corners of the generator.

(Fig 1.13).

Note

If you are unfamiliar with ratchet buckles scan the QR code to learn more.

Fig. 1.11

Note

Ensure the back of the ratchet is facing

the case, this ensures you can open and

close the ratchet handle without issue.

WARNING

Never mount the Kevlar Strap so that it blocks, or is in direct line of, the exhaust. The Kevlar

will not burn or snap but blocking the exhaust can damage the inverter generator.

Fig. 1.12

Strap Guides