Product Manual

Table Of Contents

Page: 9 of 24

l. Once the Angle Braces are in the desired location, open and close the ratchet

handle 1 or 2 times to begin tightening the system (Fig1.14). Do not over tighten

the system so tight that you cannot make any adjustments to the placement of

the Angle Braces.

m. Make final adjustments to the

Angle Braces location to ensure

they are on the corners of the

case, at the bottom of the

electrical panel and not

blocking the exhaust.

n. Finish by tightening the Kevlar®

ratchet strap 1-2 times until

the strap is tight enough to

make a light “thrum” when the

strap is plucked (much like a

guitar string). Ensure to not

over tighten the strap as it can

warp or crack your case.

Fig. 1.15

Note

To loosen the ratchet: Pinch the release lever

towards the ratchet handle (Fig 1.15) and

open the ratchet handle all the way and pull

the open handle causing the strap to unwind.

Fig. 1.13

Fig. 1.14