Product Manual

Table Of Contents

Page: 15 of 20

Converting your Handles

The handle of these generators are

attached to the frame with

4 carriage bolts. You must replace these

bolts with either quick detach pins (Fig

5.4 & 5.5) OR GenTent universal folding

handles. (Fig 5.6-8) The GenTent should

be initially installed with the handles off

the generator.

Convert Handles to Quick Detach Pins

This option allows the handles to be

quickly detached/re-attached. Fig

5.4 & 5.5 show two different types of

quick detach pins, a clevis pin in Fig 5.4

with a hitch pin clip, and a quick detach

ring pin in Fig 5.5, available at most

hardware stores. You will need four (4) 5/16” x 2” pins.

To move the generator, remove the elastic from the left and right of the electrical panel

and lift the canopy up. Install the handle with the quick detach pins and move the

generator. When it becomes time to use the generator, move it into place outdoors,

remove the handles and put the elastics back in place under the GenTent clamps to the

left and right of the electrical panel.

Fig. 5.1

Fig. 5.2

Fig. 5.3