Installation Manual

Revision Date: 3/27/2011 Page: 13 of 21
1. Test the Auto-Dimming feature.
a) With the vehicle in a fairly well-lit area, cover the forward looking photo-
cell on the back of the mirror with your hand or a dark cloth.
b) Turn the ignition to the “ON” position.
c) To make sure the auto-dimming feature is on, verify that the GREEN
LED to the left of the center button is on. If it is not on, press the “
”
button to turn the GREEN LED on.
d) At this time, the mirror will begin to darken.
e) Remove your hand or the cloth from the forward looking photo cell and
the mirror will begin to clear.
2. Test the Compass feature (Not applicable for all models).
a) Verify that either a direction, such as NE, or “C” is displayed in the
display window. If not, ensure the compass feature is turned on by
pressing the “ ” button.
Note: If your mirror is a single button mirror, press the “ ” button once to disable
the auto-dimming. Press and hold the “ ” button for 3 seconds to disable the com-
pass, if applicable.
Note: If your mirror has HomeLink
®
buttons, press the “ ” button once to disable
the auto-dimming. Press the “
” button once to disable the compass.
3. Test the HomeLink
®
feature (Not applicable for all models).
a) Turn the ignition to the “OFF” position (unless you connected the BLUE
wire to a switched +12 Volt circuit, in which case the ignition must
remain in the “ON” position).
b) Ensure that the Compass display is no longer visible and the Green
LED is no longer on (unless you connected the BLUE wire to a
switched +12 Volt circuit).
c) Press each HomeLink
®
button (“
,
” “
,
” & “
”), one at a time, and
verify that the LED indicator to the left of the center button illuminates
with a RED LED when buttons are pressed.
d) Testing is now complete.
4. Reinstall in reverse order, all trim pieces removed during installation.
5. Verify each reinstalled component for proper fit and function.
C
Fig. 3-1
C
Fig. 3-2
C
Fig. 3-3
Test Preparation and Testing
WARNING: DO NOT spray glass cleaner or other cleaning liquid directly onto
the mirror as it may damage the electronics.
CAUTION
!
Indicator LED -
Green
“ ” Button
Compass Display
“ ” Button
Indicator LED -
Green
Indicator LED
- Red
HomeLink
®
Buttons
(“
,
” “
,
” & “
”)