Installation Manual

ManualsBrandsGentex ManualsAutodimmingAutodimming Mirror

Revision Date: 3/27/2011 Page: 15 of 21

b) For first time training, begin programming by clearing memory. Press

and hold the two outer HomeLink

buttons (“ ” & “ ”), releasing only

when the HomeLink

indicator light begins to flash after 10 seconds. Do

not hold buttons for more than 20 seconds.

(Fig. 4-2)

NOTE: Do not repeat this step when programming additional devices to remaining

buttons.

NOTE: It is also suggested that upon the sale of the vehicle, the programmed

HomeLink

buttons be erased for security purposes. To erase the programmed but-

tons, perform the procedure shown in step “b).’

(Fig. 4-2)

c) Position the hand-held transmitter 1-3 inches away from the HomeLink

button, keeping the HomeLink

indicator light in view.

d) Using both hands, simultaneously press and hold both the desired

HomeLink

button and hand held transmitter button. DO NOT release

until the HomeLink

indicator light flashes slowly and then rapidly.

e) When the indicator light flashes rapidly, both buttons may be released.

(The rapid flashing indicates successful training.) (Fig 4-3)

NOTE: Canadian radio-frequency laws require transmitter signals to “time-out”

or quit after several seconds of transmission - which may not be long enough for

HomeLink

to pick up the signal during programming. Similar to this Canadian law,

some U.S. gate operators are designed to “time-out” in the same manner.

If you live in Canada or you have difculties programming a gate operator by using

the “Programming” procedures (regardless of where you live), replace the above

Programming HomeLink

step “d)” with the following:

Using both hands, simultaneously press and hold both the desired

HomeLink

button and hand held transmitter button. During program-

ming, your hand-held transmitter may automatically stop transmit-

ting. Continue to press and hold the desired HomeLink

button while

you press and re-press (“cycle”) your hand-held transmitter every two

seconds until the frequency signal has been learned. The indicator light

will flash slowly and then rapidly after several seconds upon success-

ful training. DO NOT release until the HomeLink

indicator light flashes

slowly and then rapidly. When the indicator light flashes rapidly, both

buttons may be released. (The rapid flashing indicates successful train-

ing.)

NOTE: If programming a Canadian garage door opener or gate, it is advised to

unplug the device during the HomeLink

programming and also if performing the

“cycling” process to prevent possible motor burn-up.

f) Press and hold the trained HomeLink

button and observe the indicator

light. (Fig 4-4)

g) If the indicator light is solid/continuous, training is complete and your

device should activate when the HomeLink

button is pressed and

released.

h) If the indicator light blinks rapidly for 2 seconds and then turns to a

solid/continuous light, proceed with the following training instructions for

a rolling code device.

Fig. 4-3

Fig. 4-4

Fig. 4-2