Installation Manual

Revision Date: 3/27/2011 Page: 16 of 21

NOTE: A second person may make the following steps quicker and easier. Please

use a ladder or other device. Do not stand on your vehicle to perform the next

steps.

i) At the garage door opener receiver (motorhead unit) in the garage,

locate the “learn” or “smart” button (usually near where the hanging

antenna wire is attached to the unit). If there is difficulty locating the

training button, reference the garage door opener’s manual or contact

HomeLink

customer support at 1-800-355-3515.

j) Press and release the “learn” or “smart” button (the name and color of

the button may vary by manufacturer). (Fig 4-5)

NOTE: Once the button is pressed, there are 30 seconds in which to initiate the

next step.

k) Return to the vehicle and firmly press and hold the SAME partially

trained HomeLink

button for two seconds and release. Repeat the

“press/hold/release” sequence up to 3 times, if necessary, to complete

the training process. (Fig 4-6)

l) After the 30 seconds are up from pressing the garage door opener

receiver (motorhead unit) in the garage, press and hold the trained

HomeLink

button and observe the indicator light. (Fig 4-7)

m) If the indicator light is solid/continuous, training is complete and your

device should activate when the HomeLink

button is pressed and

released.

n) To train additional HomeLink

buttons, begin with step “c).”

NOTE: Retain the original hand-held transmitter of the RF device you are program-

ming for use in other vehicles, as well as for future HomeLink

programming.

FCC ID: NZLGHSHL4. IC: 4112A-GHSHL4

Fig. 4-7

Fig. 4-6

Fig. 4-5