Installation Manual

Revision Date: 3/27/2011 Page: 3 of 21
Fig. 1-1
Fig. 1-2
Fig. 1-3
Fig. 1-4
1. Remove OEM mirror.
a) Loosen T20 Torx screw on mirror mount and slide mirror upwards, par-
allel to windshield. (Fig. 1-1)
- - - OR - - -
b) Insert 4mm Flat Head screwdriver at bottom of mirror mount to disen-
gage locking tab. Continue to press upwards with screwdriver and slide
mirror upwards, parallel to windshield. (Fig. 1-2)
NOTE: Gently wiggling mirror while sliding upwards will assist removal.
- - - OR - - -
c) Insert Panel Removal Tool under tab at bottom of mirror mount to
disengage locking tab. Lift tab away from windshield and slide mirror
upwards, parallel to windshield. (Fig. 1-3)
NOTE: Gently wiggling mirror while sliding upwards will assist removal.
2. Partially remove driver-side door seal.
a) Pull back door seal past top of A-pillar trim and down past kick-plate
and scuff plate. (Fig. 1-4)
Disassembly
Do NOT use excessive force; damage to windshield could occur.
CAUTION
!
Do NOT use excessive force; damage to windshield could occur.
CAUTION
!
Do NOT use excessive force; damage to windshield could occur.
CAUTION
!