Installation Manual

Revision Date: 3/27/2011 Page: 8 of 21
1. Attach EC mirror.
a) Hold the mirror mount and slide downwards as far as possible over the
windshield button, until fully seated. (Fig. 2-1)
b) Using a T20 Torx, tighten the mirror mounting bracket screw to 15 lb-in.
2. Plug EC mirror harness connector into back of mirror. (Fig. 2-2)
3. Route EC mirror harness from mirror to headliner.
a) Route EC mirror harness into groove of wire cover and attach wire
cover to mirror base.
b) Partially route EC mirror harness into headliner.
c) Slide upper portion of wire cover up to headliner so the “forks” are held
by the headliner. (Fig. 2-3)
4. Route EC mirror harness through headliner to driver-side A-pillar.
a) Reach in between the headliner and the vehicle roof to feel the gap, or
channel, between the two. Route the EC mirror harness into this chan-
nel over to the A-pillar. (Fig. 2-4)
Fig. 2-1
Fig. 2-2
Fig. 2-3
Installation
Fig. 2-4
Do NOT overtighten screw; damage to windshield or mount could occur.
CAUTION
!