Installation Manual

Revision Date: 3/27/2011 Page: 9 of 21
5. Route EC mirror harness down driver-side A-pillar.
a) Route EC mirror harness along OEM harness down A-pillar into dash.
b) Secure harness to OEM wire harness with included wire ties. (Fig. 2-5)
NOTE: If no OEM wire harness is available, foam tape may be used to secure the
EC mirror harness to the A-pillar.
6. Route EC mirror harness through dash to fuse panel area.
a) Route EC mirror harness through dash from A-pillar down to fuse panel
area. (Fig. 2-6)
7. Route EC mirror harness into fuse panel area.
a) Route EC mirror harness from dash over to the fuse panel area in
preparation of connecting to power and ground. (Fig. 2-7)
8. Connect EC mirror harness to power.
a) You will need to find a supply wire in your vehicle that provides +12
Volts when the vehicle ignition is in the ACC or ON position (RED wire
on EC mirror harness). For HomeLink
®
controls you may choose to
use the same switched ignition circuit or a constant +12 Volt circuit
(BLUE wire on EC mirror harness). If choosing to use a constant
+12 Volt circuit, you will need to find a wire supply in your vehicle that
provides +12 Volts when the vehicle is in the ON and OFF position.
(Fig. 2-8)
NOTE: Your automotive repair shop may be able to advise readily available loca-
tions for connecting to these power sources.
Fig. 2-5
Fig. 2-6
Fig. 2-7
BLACK - GROUND
RED - IGNITION
BLUE - BATTERY (or IGNITION)
GREEN - REVERSE
VIDEO - TO CAMERA
Fig. 2-8
Do NOT secure EC mirror harness to Airbag or drain tubes.
CAUTION
!
Ensure EC mirror harness is away from sharp edges and pinch points. Use
wire ties or foam tape to protect harness if necessary.
CAUTION
!