Installation Manual

Page 3 of 10 Revision A 550-0427
8. Remove OEM mirror. (Fig. 6,7 or 8)
a) Loosen #T20 torx screw on mirror mount and slide mirror
upwards off from windshield button. (Fig. 6)
- - OR - -
b) Insert 4mm into opening at bottom of mirror mount to disengage
locking tab and slide mirror upwards off from windshield button.
(Fig. 7)
NOTE: Gently wiggling mirror while sliding upwards will assist
removal.
- - OR - -
c) Insert panel removal tool into opening at bottom of mirror mount
to disengage locking tab and slide mirror upwards off from
windshield button.
(Fig. 8)
NOTE: Gently wiggling mirror while sliding upwards will assist
removal.
1. Attach auto-dimming mirror.
a) Hold the mirror and slide the mirror downwards over wind-shield
button until fully seated. (Fig. 9)
b) Using #T20 torx driver, tighten the mirror mounting bracket
screw to 1.3 ft-lbs (17.8 kg-cm). DO NOT OVERTIGHTEN
NOTE: You will need to find a supply wire in your vehicle that provides
+12V when vehicle is running or the key is in the ON or ACC
position. You will also need to find a supply wire that provides
+12V constant power when vehicle is both ON and OFF. Your
automotive repair shop may sometimes be able to advise readily
available locations for connecting to these power sources.
A TIP: The cigarette lighter or power port receptacle may be a source of
switched +12V or constant +12V, depending on vehicle make.
1. Locate ignition (+12V switched) wire.
a) Using a multi-meter, find a wire exiting the fuse block or junction
block that tests +12V and is controlled by the ignition switch.
Operate vehicle accessories (power windows, door locks, power
mirrors, etc.) to ensure that voltage does not drop on this wire.
(Fig. 10)
b) Ensure power in this wire is off when vehicle key is OFF and
label wire "IGNITION."
2
Auto-Dimming Mirror Installation
CAUTION
!
Do not use excessive force. Damage to windshield could occur.
3
Route Auto-Dimming Mirror Harness to Vehicle Power
1.3 ft-lbs
CAUTION
!
6
8
9
10
7
CAUTION
!