Installation Manual

Page 4 of 10 Revision A 550-0427
2. Locate constant power (+12V constant) wire.
a) Using a multi-meter, find a wire exiting the fuse block that tests
+12V with vehicle ignition in the ACC, ON and OFF positions.
(Fig. 11)
b) Ensure power in this wire is still present when vehicle key is
OFF and label wire "CONSTANT."
3. Disconnect vehicle's negative battery terminal. (Fig. 12)
4. Plug auto-dimming mirror harness into back of mirror. (Fig. 13)
5. Route harness up to vehicle headliner. (Fig. 14)
a) Install optional wire cover (if purchased). (Fig. 15)
6. Route haress across vehicle headliner to top of A-pillar on side of
vehicle where vehicle connection wires / fuse block were found.
a) Use panel removal tool to ensure harness is tucked between
headliner and roof of vehicle. (Fig. 16)
11
12
13
14
15
16