Installation Manual

Page 5 of 10 Revision A 550-0427
7. Route harness down A-pillar. (Fig. 17)
NOTE: Harness will be secured later in installation procedure.
8. Route harness to vehicle connection wires.
a) Using fish-wire, route harness from base of A-pillar through dash
and into connection wire / fuse block area. (Fig. 18)
9. Attach wire tap to vehicle wire marked IGNITION.
a) Center blade of wire tap on IGNITION wire and close wire tap
with pliers. (Fig. 19)
b) Ensure both halves of wire tap are closed completely and
locking tab is engaged.
10. Connect auto-dimming mirror harness switched power wire to
vehicle wire marked IGNITION.
a) Locate the harness wire with WHITE STRIPE.
b) Insert spade terminal on WHITE STRIPE wire into the wire tap
on the vehicle wire labeled IGNITION. (Fig. 20)
11. Attach wire tap to vehicle wire marked CONSTANT.
a) Center blade of wire tap on CONSTANT wire and close wire tap
with pliers. (Fig. 21)
b) Ensure both halves of wire tap are closed completely and
locking tab is engaged.
12. Connect auto-dimming mirror harness constant power wire to
vehicle wire marked CONSTANT.
a) Locate the SOLID BLACK harness wire with spade terminal.
b) Insert spade terminal on SOLID BLACK wire into the wire tap
on the vehicle wire labeled CONSTANT. (Fig. 22)
19
22
21
20
18
17