Installation Manual

Page 6 of 10 Revision A 550-0427

13. Connect auto-dimming mirror harness ground wire.

a) Locate a ground bolt near connection / fuse block area and

remove.

NOTE: Bolt locations may vary but common locations are in the

kick plate / cowl cover area or parking brake release

handle.

b) Install ring terminal of harness over bolt and reinstall. (Fig. 23)

1. Reconnect negative battery cable.

2. Turn the ignition switch ON/ACC position.

3. With the vehicle in a fairly well-lit area, perform the following:

a) To make sure the auto-dimming feature is on, verify that the

green LED to the left of the center switch is on. If it is not on,

push the switch to turn the green LED on.

b) Cover the forward looking photocell on the back of mirror with a

dark cloth or towel. (Fig. 24)

In a few seconds, the mirror will begin to darken.

NOTE: Time to darken will vary with ambient light level.

c) Remove the cover from the forward looking photo cell and the

mirror will begin to clear.

d) Verify that either a direction, such as NE, or “CAL” is displayed

in the display window. If not, ensure the feature is turned ON

by pressing the button.

4. Turn the ignition key to the OFF position.

5. Push each HomeLink

button (if equipped), one at a time, and

verify that LED indicator to the left of the center switch illuminates

with a red LED. (Fig. 25)

6. If mirror is equipped with maplights, push each maplight button

to ensure lights are operational. (Fig. 26)

7. Testing is now complete.

Testing.

Red LED

HomeLink Buttons

Maplight Buttons