Installation Manual

Page 8 of 10 Revision A 550-0427
To Operate the HomeLink
®
Feature:
Please refer to the programming instructions outlined in this manual or:
a) Visit the HomeLink
®
website at www.homelink.com
b) Call the HomeLink
®
customer support line at 1-800-355-3515
WARNING! Before programming HomeLink
®
to a garage door opener or gate
operator, make sure that people and objects are out of the way of the device to
prevent potential harm or damage. When programming a garage door opener, it is
advised to park outside of the garage. Do not use HomeLink
®
with any garage door
opener that lacks safety stop and reverse features as required by U.S. federal
safety standards (this includes any garage door opener model manufactured before
April 1, 1982). A garage door that cannot detect an object – signaling the door to
stop and reverse – does not meet current U.S. federal safety standards. For more
information, contact HomeLink
®
at www.homelink.com or by calling 1-800-355-
3515.
1. To begin, press and hold the 2 outer HomeLink
®
buttons (to clear
memory) until the indicator light (LED) blinks slowly (approximately 20
seconds). (Fig. 28)
2. Release both buttons.
NOTE: Do not hold the buttons for longer than 30 seconds. Do not
repeat this step when programming additional devices to
remaining buttons.
3. Position the end of the hand-held transmitter 1-3 inches away from the
HomeLink
®
button you wish to program while keeping the indicator light
in view.
4. Simultaneously press and hold both the chosen HomeLink
®
and hand-
held transmitter buttons. (Fig. 29)
Do not release the buttons until step 5 has been completed.
8
HomeLink
®
Feature and Programming Instructions
● Press and Hold for 20s seconds…
● LED blinks slowly…
● Release buttons
● Press and hold both…
●
LED blinks fast…
●
Release both buttons
29
28