User's Manual

Suggested Owners Manual Text for Gentex Auto-Dimming Mirror with RCD, Z-Nav
®
, and HomeLink
®
To train rolling code devices, follow these instructions:
1. At the garage door opener receiver (motor-head unit) in the garage, locate the
“learn” or “smart” button. This can usually be found where the hanging antenna wire
is attached to the motor-head unit. Exact location and color of the button may vary
by garage door opener brand.
If there is difficulty locating the training button,
reference the device owner’s manual or please visit our Web site at
www.homelink.com
.
2. Firmly press and release the “learn” or “smart” button (which activates the “training
light”). Note: There are 30 seconds in which to initiate step3.
3. Return to the vehicle and firmly press, hold for two seconds and then release the
desired HomeLink
®
button. Repeat the “press/hold/release” sequence a second
time to complete the programming. (Some devices may require you to repeat this
sequence a third time to complete the programming.)
4. Press and hold the just-trained HomeLink
®
button and observe the red Status
Indicator LED. If the indicator light stays on constantly, programming is complete
and your device should activate.
5. To program the remaining two HomeLink
®
buttons, follow either steps 1 through 4
above for other Rolling Code devices or steps 2 through 5 in Standard Programming
for standard devices.
Gate Operator & Canadian Programming
During programming, your handheld transmitter may automatically stop transmitting.
Continue to press the Integrated HomeLink
®
Wireless Control System button (note
steps 2 through 4 in the Standard Programming portion of this document) while you
press and re-press (“cycle”) your handheld transmitter every two seconds until the
frequency signal has been learned. The indicator light will flash slowly and then rapidly
after several seconds upon successful training.
Operating HomeLink
®
To operate, simply press and release the programmed HomeLink
®
button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.). For convenience, the hand-held
transmitter of the device may also be used at any time.
Reprogramming a Single HomeLink
®
Button
To program a new device to a previously trained HomeLink
®
button, follow these steps:
1. Press and hold the desired HomeLink
®
button. Do NOT release until step 4 has
been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches away from the HomeLink
®
surface.
3. Press and hold the handheld transmitter button. The HomeLink
®
indicator light will
flash, first slowly and then rapidly.
4. When the indicator light begins to flash rapidly, release both buttons.
5. Press and hold the just-trained HomeLink
®
button and observe the red Status
Indicator LED. If the indicator light stays on constantly, programming is complete
and your new device should activate.