Specification

Product Data Sheet
All Purpose Bonding Adhesive LVOC 1168
GenTite™ RRS
250 West 96
th
Street
Indianapolis, IN 46260
800-443-4272 ● www.GenTite.com
Description:
GenTite All Purpose Bonding Adhesive LVOC 1168 is a solvent based contact adhesive designed for bonding Rubber Roofing
(Black), Rubber Roofing (White), and TPO Roofing (White) to substrate, such as insulations, wood, metal, concrete and other
acceptable substrates. Please visit www.GenTite.com for more information about this product and its proper use.
Physical Properties:
PROPERTY
TYPICAL VALUES
Base
Blend of Polychloroprene Rubber
Color
Yellow
Solvents
Blend of Acetone, Toluene, Methyl Acetate, 4-Chlorobenzotrifluoride
Viscosity
4,000 – 6,000 cps, R.V.F. spindle @ 10 RPM
Specific Gravity
1.1
Weight/Gallon
9.2 lb/gal (1.1 kg/L)
Installation:
Bonding surfaces must be clean, smooth, dry, and free of sharp edges, loose materials and other contaminants.
Stir the adhesive thoroughly before and during use to achieve a uniform mix with no sediment on the bottom and no marbling evident.
DO NOT THIN MATERIAL.
Fold roofing membrane back so one-half (½) of the underside of the panel is exposed.
Apply the Bonding Adhesive to the substrate and the membrane at about the same time using a 9” (228 mm) medium nap roller. A
coverage rate of 45 – 60 ft
2
/gal (1.1 – 1.4 m
2
/L) may be achieved depending on the substrate. Coverage rates will vary depending on
substrate texture and porosity. When applying the Bonding Adhesive LVOC 1168, ensure a 100% uniform coverage of both surfaces
that will be adhered. Care should be taken not to apply Bonding Adhesive LVOC 1168 within the seam areas. Avoid globs or
puddles of adhesive.
Allow adhesive to flash off or dry completely. To determine if the adhesive is dry, touch down on the adhesive with a clean dry finger.
As you touch the adhesive surface, push down to check that the adhesive has completely dried below the surface. If either test
exposes wet adhesive when the finger is lifted, then the adhesive is not ready for bonding. Flash off time will vary depending on
ambient conditions.
Apply the adhesive coated membrane into the adhesive coated substrate in a continuous motion avoiding wrinkles and folds.
Using a push broom, apply firm downward pressure to the membrane to promote 100% adhesion to the substrate.
Install adjoining panels in a similar manner, lapping edges a minimum of 3” (76 mm) in preparation for seaming.
All Purpose Bonding Adhesive LVOC 1168 can be applied using solvent resistant paint rollers, power rollers, or spray equipment.
Product Data:
SIZE
CONTENTS
PRODUCT #
1 gallon (3.8 Liter)
4 Cans per Carton
W59GT30125
3 gallon (11.4 Liter)
n/a
W59GT30126
5 gallon (18.9 Liter)
n/a
W59GT30127