Owner's manual
40
Enable UPnP – select to enable UPnP (Universal Plug and Play connectivity) service. The UPnP
enables APC communicate with other network devices automatically opening required ports, without
manual intervention.
Enable DMZ – select to enable DMZ. DMZ opens all TCP/UDP ports to particular IP address.
It allows
setting up servers behind the APC. The feature is used commonly for setting up VoIP or Multi- Media
servers.
Public port – specify the port that will be accessed externally using the public IP address.
Private host – specify the IP address behind NAT that public traffic will get forwarded to.
Private port – specify the listening port on private computer behind NAT.
Protocol – select type of forwarding traffic: TCP or UDP.
7.2.13 Static Routes
Static routes is active only in Router network mode.
A routing rule is defined by the destination subnet (Destination IP address and netmask), interface
and/or gateway where to route the target traffic. A data packet that is directed to the destination
network is routed to the specified
router
‟
s
interface or to another gateway router. To add a new static
route, specify the following parameters:
Destination IP – specify the destination IP address.
Netmask – specify destination netmask.
Gateway – specify the gateway address for the route. 0.0.0.0 stands for the default gateway of the
selected interface.
Interface – select interface for the route.
7.3 Services
7.3.1 WNMS
Wireless Network Management System (WNMS) is a centralized monitoring and management system