Manual

42
SNMP Traps Settings
Manager address – specify the IP address or hostname of SNMP Trap receiver.
Manager port – specify the port number of the Trap receiver. Default port number is 162.
Trap community - specify the SNMP community string. This community string acts as password
between SNMP manager and device by default Trap community string is "public".
Use informs – select to wait for an acknowledgment from SNMP manager that trap was received.
Retry count – specifies maximum number of times to resend an inform request [1-10]. Default: 5.
Retry timeout – specifies number in seconds to wait for an acknowledgment before resending
request [1-10]. Default: 1.
SMTP Settings
Server address – specify the IP address or hostname of the networked SMTP server.
Server port – specify the SMTP Port Number is the port number used by the networked SMTP
server. By default the port number is 25.
Source e-mail address – specify the e-mail address that will be used by the device.
Destination e-mail address – specify the e-mail address where the device will send the alert
messages.
E- Mail notification interval – specify interval in seconds at which the e-mail notification will be
sent from the device [0-86400]. If 0 specified, then device will send an e-mail notification immediately
after unexpected system behavior.
7.3.3 SNMP
SNMP is the standard protocol that is widely used for remote network management over the Internet.
With the SNMP service enabled, the device will act as SNMP agent.