Zoom3D_usermanual

16 - Camera operation
If the measure with laser-spot is activated the panel is similar to the following:
Activates the camera visualization; the
central button allows to activate the
double view: camera and graphic
Activates the graphic visualization
Zoom in the camera or the graphic
view
Zoom out the camera or the graphic
view
Increase the camera brightness
Decrease the camera brightness
Activates continue measuring
Start/Stop measure
Zoom3D control window
Current target type and target type
choice
Setup window
Utilities
If the measure with target is activated the panel is similar to the following:
Activates the camera visualization; the
central button allows to activate the
double view: camera and graphic
Activates the graphic visualization
Zoom in the camera or the graphic
view
Zoom out the camera or the graphic
view
Increase the camera brightness
Decrease the camera brightness
Measure position on target: left,
center, right
Target height
Activates continue measuring
Strat/Stop measure
Target locking status and Zoom3D
control window
Current target type and target type
choice
Setup window
Utilities
Camera operation
The camera is a main element of the Zoom3D because it’s the only way to check the
collimation point and consequently the point that will be measured.
Moving the pointing direction
To move the pointing direction click on screen in correspondence of the desired position; the Zoom3D
will move to aim the indicated point.