Zoom3D_usermanual

General description of the system - 19
Measure with laser spot; the measured point corresponds exactly to the point indicated by
the laser.
Measure with laser spot on vertical support. Set the height of the support with the button
Target height. The calculated point corresponds to the point at the bottom end of the
support.
Measure on small target. The measured point corresponds to the center of the target.
Measure with small target on vertical pole. Set the height of the pole with the button Target
height. The calculated point corresponds to the point at the bottom end of the pole.
Measure with small target upside down. The target can be used with the tip pointing down
and has a fixed height from the ground.
Measure on big target. The measured point corresponds to the center of the target.
Measure with big target on vertical pole. Set the height of the pole with the button Target
height. The calculated point corresponds to the point at the bottom end of the pole.
Measure with big target upside down. The target can be used with the tip pointing down and
has a fixed height from the ground.
Target height
Target height: For targets Laser spot with pole, Target small on pole and Target big on pole
it’s necessary setting the height from the ground of the support; the height is referred to the
distance between the center of the target and the bottom end of the pole.
Activating the laser spot
Laser pointer: by this button it’s possible to activate and deactivate the laser pointer. The
laser pointer allows to check the measure direction on the surface to be measured.