Zoom3D_usermanual
20 - Working with targets and Robotic module
Continuous measures
Measure continuous: by this button it’s possible to activate and deactivate the continuous
measure of the target. To stop the continuous measure press STOP button. The continuous
measure is available only in some commands.
Remote control
It’s possible to start the measure from the remote control pressing the red button.
Working with targets and Robotic module
Robotic module enables XPAD 3D to recognize, follow and measure targets. The target is automatically
recognized by analyzing images coming from the camera. When the target is recognized it’s shown on
the image with a red rectangle.
To recognize target it’s necessary that this one has a sufficient dimension in the camera view; for this
reason it’s necessary to change the level of zoom of the camera basing on the distance. To this purpose
it’s also available an option that automatically adapts the level of zoom.
To maintain target locked it’s necessary that this one is always visible in the camera field of view; if the
target moves too quick and goes out of the camera field of view you can operate like this:
1. Starting the manual research of the target right or left
2. Specifying your position in the Panorama
3. Specifying your position on graphic window
4. Activating an automatic research of the target; one available option is the research toward the last
movement direction; when the target is lost, XPAD 3D starts automatically a research in the same
direction of the last movement of the target.
5. Using the joystick to manually rotate the Zoom3D toward your position.
In the side control panel a button indicates the locking and following status of the target:
Locked: target has been recognized and is followed by Zoom3D.
Unlocked: target is not followed by Zoom3D.
Clicking on button you enter in to the window allowing to fully control the Zoom3D.