Zoom3D_usermanual

22 - Working with targets and Robotic module
Automatic research of the lost target
When target is lost it’s possible activating an automatic research:
None: automatic research is not started. The target must be searched manually using a
position function.
Last direction: Zoom3D is rotated toward the same direction of the target before its loss.
Rotation goes for some time; if the target is not found the rotation stops.
Autozoom and Autozoom on Measure
Autozoom: when this option is active the target dimensions are continuously analyzed; when
dimension is too big or too small the level di zoom is automatically adapted to ensure always
the right dimension of the target.
Autozoom on Measure: when this option is active, the measure is performed after the target
is zoomed at the maximum possible level; this way the calculation of the center of the target
is performed with the best precision. At the end of the measure, the zoom is set on previous
level.
Research from graphic window
It’s possible to activate some of the previous functions directly from the graphic window without
opening the Zoom3D control window.
The position of the Zoom3D is shown with the corresponding target direction; click on the dashed line to
view the local menu:
From the local menu it’s possible to start research of the target in the modes still explained; moreover
it’s available the function I’m here. This function allows to indicate directly on the graphic view your
position; the Zoom3D will rotate toward the indicated position.
Measure of the target with offset
When the Target small or Target big is selected, it’s possible to specify the measure position:
Top Left: it’s measured the point finding on the corner top left of the target.