Zoom3D_usermanual

Measure - 43
Other tools
There are available several utility commands allowing to perform some operations directly
in the measuring window without requesting to return in the main window.
d
Setting of the reference elevation
It’s possible to assign a reference elevation to a point to be measured; the elevation of
all next points measured will be calculated referring to the elevation of the reference
point.
1. Measure the point representing la reference elevation
2. Assign the elevation value.
Measuring a reference point
The command allows to measure a new reference point to use in the Relocation
procedure of the Zoom3D.
1. Measure the reference point with precision
2. With the reference point it’s shooted also the photo allowing to select quickly and sharply the point
within Relocation procedure.
Relocation
Relocation of the Zoom3D it’s a necessary operation to allow continuing to operate with
Zoom3D inside the same site and with the same reference system. Please refer to
chapter Relocation and Reference points.
Generic photo
The command allows to shoot a photo at high resolution. It’s possible managing photos
by the command Photo of the main menu.
Rotation of the drawing
The command allows to rotate the drawing at a certain angle. In this way it’s possible to
visualize the drawing in the better way referring to the surveyed site.