Zoom3D_usermanual

Projection on surfaces - 55

3. Press the button Move and select the operation Move on point to move the whole drawing on the

reference point that must be selected.

4. Press the button Move and select the operation Move the value to move the whole drawing by a

desired quantity.

5. When movement is completed Press the button to return to previous step.

Rotate drawing on rotation point

1. After having selected a point press the button Rotate.

2. Press the two buttons Rotate on Left and Rotate on Right to rotate the whole drawing

3. Press the button Rotate to rotate the whole drawing clockwise or counterclockwise of 90°

4. When the rotation is completed press the button to return to previous step.

Rotate drawing on a line

1. Select a line of the drawing

2. Press the button to rotate the whole drawing in order to make the selected line perfectly

vertical.

3. Press the button to rotate the whole drawing in order to make the selected line perfectly

horizontal.

4. Press the button to rotate the whole drawing so that the selected line is parallel to a

reference line to select.

Projection

1. Press Accept to accept the alignment and proceed with projection of the points on the reference

surface

2. Select the point to stakeout; the point can be selected also using the four buttons with direction

arrows or pressing the corresponding buttons on the remote control.

3. Press . Zoom3D automatically position itself on desired position.

4. The measured point is marked with symbol .

5. It’s possible to use a projection plane different from the one defined at the beginning: before

pressing position approximately the target on the plane on which you want to perform the

projection of the selected point; this way the point selected will be projected perpendicularly to

first reference plane up to meet the preset measure plane. With this solution it’s possible not only

staking points on the main plane but also staking the same points on an opposite plane, parallel or

not to the main plane.

6. Press to stop projection procedure.