Product Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 User Interface
- 4 Operation
- 4.1 Main Menu
- 4.2 System Information
- 4.3 Setting Up the TPS Instrument
- 4.4 Setting up for Remote Control (with the RadioHandle)
- 4.5 Connecting to a Personal Computer
- 4.6 Power Functions
- 4.7 Batteries
- 4.8 Working with the Memory Device
- 4.9 Working with Bluetooth
- 4.10 LED Indicators
- 4.11 Guidelines for Correct Results
- 5 Settings
- 6 Apps
- 7 Care and Transport
- 8 Technical Data
- 8.1 Angle Measurement
- 8.2 Distance Measurement with Reflectors
- 8.3 Distance Measurement without Reflectors
- 8.4 Distance Measurement - Long Range (LO mode)
- 8.5 Automatic Prism Aiming AiM
- 8.6 Prism Search (Scout) - only available at Zoom90
- 8.7 Conformity to National Regulations
- 8.8 General Technical Data of the Product
- 8.9 Scale Correction
- 8.10 Reduction Formulas
- 9 Software Licence Agreement
- 10 Glossary
- Appendix A Menu Tree
- Appendix B Directory Structure
- Appendix C Pin Assignments
4.9 Working with Bluetooth
Zoom70/90 instruments can communicate with external devices by a Bluetooth connection. The
instrument Bluetooth is a slave only. The Bluetooth of the external device will be the master, and
therefore will control the connection and any data transfer.
1. On the instrument, ensure that the communication parameters are set to Internal
Bluetooth or Bluetooth Handle. Refer to "5.3 Communication Settings".
2. Activate Bluetooth on the external device.
The steps required depend on the Bluetooth driver and other device-specific configu-
rations. Refer to the User Manual of the device, for information on how to configure
and search for a Bluetooth connection.
The instrument appears on the external device.
☞
Some devices ask for the identification number of the Bluetooth. The default number
for a Zoom70/90 Bluetooth is 0000. This can be changed by:
1. Select Settings from the MAIN MENU.
2. Select Comm. from the SETTINGS menu.
3. Press CONF from the COMMUNICATION SETTINGS screen.
4. Choose Pin from the Internal Bluetooth screen. Enter a new Bluetooth code.
5. Press OK to confirm the new Bluetooth code. Before the new Pin is active, a
reboot of the system would be required.
3. When the external Bluetooth device has located the instrument for the first time, a
message displays on the instrument. The message contains the name of the exter-
nal device and the requesting confirmation that connection to this device should be
allowed.
Press YES to allow or
press NO to disallow this connection.
4. The instrument Bluetooth sends out the instrument name and serial number to the
external Bluetooth device.
5. All further steps must be made in accordance to the User Manual of the external
device.
4.10 LED Indicators
Description
The RadioHandle has Light Emitting Diode indicators. They indicate the basic RadioHandle sta-
tus.
Diagram of the LED Indicators
009860_001
abcd
a Power LED
b Link LED
c Data Transfer LED
d Mode LED
Description of the LED Indicators
IF the is THEN
Power LED off power is off.
Description
Establishing a connection
step-by-step
LED Indicators on Radio-
Handle
Operation 37