Product Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 General Information
- 2 How to Use the Locator
- 3 How to Use the Transmitter
- 4 How to Use the Conductive Rod
- 5 How to Use the Signal Clamp
- 6 How to Use the Property Connection Set
- 7 How to Use the Sonde
- 8 Care and Transport
- 9 Safety Directions
- 10 Technical Data
- 11 International Limited Warranty
- Appendix A Functional Checks
- Appendix B World Frequency Zones
- Index
100EZiSYSTEM, Functional Checks
7. Batteries Replace Replace alkaline batteries if
pack is exhausted (no
response) or if the battery
indicator light is illuminated
or flashing after display test.
Replace all batteries!
8. Power mode Return for repair Response width and peak
value similar to test unit.
9. Radio mode Return for repair Response width and peak
value similar to test unit.
10. 8 kHz Return for repair Response width and peak
value similar to test unit.
11. 33 kHz Return for repair Response width and peak
value similar to test unit.
12. Depth Mode
(Depth Locator
only)
• 8 kHz, 33 kHz
• 512 Hz, 640Hz
(xf models)
Return for repair Gives same result as test unit
(10% accuracy).
Tested by: Date:
Functional Test Check List