Product Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 General Information
- 2 How to Use the Locator
- 3 How to Use the Transmitter
- 4 How to Use the Conductive Rod
- 5 How to Use the Signal Clamp
- 6 How to Use the Property Connection Set
- 7 How to Use the Sonde
- 8 Care and Transport
- 9 Safety Directions
- 10 Technical Data
- 11 International Limited Warranty
- Appendix A Functional Checks
- Appendix B World Frequency Zones
- Index
EZiSYSTEM, How to Use the Locator 31
Current Measurement
(i550xf, i650xf and i750xf)
Current Measurement is used to identify the service to which the transmitter is attached,
this is measured in milliamperes (mA).
The transmitter is used to apply a signal (current) to the required service. The signal can
also couple to additional services making it hard to distinguish by conventional locating
techniques.
The highest current reading (mA) will be obtained when the locator is positioned over the
service which has the transmitter attached to it.
Additional information on the condition and layout of the service can be ascertained such
as a fault in the service, damage to the insulation, or a connection off the service, these are
typically indicated by sudden reduction in the current reading.
36 74 18
36 74 18