Product Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 General Information
- 2 How to Use the Locator
- 3 How to Use the Transmitter
- 4 How to Use the Conductive Rod
- 5 How to Use the Signal Clamp
- 6 How to Use the Property Connection Set
- 7 How to Use the Sonde
- 8 Care and Transport
- 9 Safety Directions
- 10 Technical Data
- 11 International Limited Warranty
- Appendix A Functional Checks
- Appendix B World Frequency Zones
- Index
EZiSYSTEM, How to Use the Transmitter 45
3.3 How to Locate a Service Using the Transmitter
Start up test The following test sequence will take place every time the Transmitter is activated.
On test Test pattern
Audio output On throughout test sequence.
LEDs LEDs are all lit throughout the test sequence.
Default mode selection 33 kHz and power output level two is automatically
selected. Induction mode is selected unless the Trans-
mitter's cable set or accessories are connected.
1