Product Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 General Information
- 2 How to Use the Locator
- 3 How to Use the Transmitter
- 4 How to Use the Conductive Rod
- 5 How to Use the Signal Clamp
- 6 How to Use the Property Connection Set
- 7 How to Use the Sonde
- 8 Care and Transport
- 9 Safety Directions
- 10 Technical Data
- 11 International Limited Warranty
- Appendix A Functional Checks
- Appendix B World Frequency Zones
- Index
EZiSYSTEM, How to Use the Transmitter 47
Using the Transmitter in
Connection mode
1. Plug the Transmitter’s cable set into the connection socket.
2. Connect the black cable to the Earth Pin, ensuring that no services are below push the
Earth Pin into the ground.
3. Connect the red cable to the service.
4. Switch the Transmitter on, observe the Connection mode LED is illuminated and the
battery level is adequate. Change batteries when indicated.
5. Select the required power output level and frequency output. A good level of tracing
signal is indicated when the power output LED & audible tone changes from pulsed to
continuous.
6. Trace the signal using the Locator set to the same operating mode. Refer to "2 How to
Use the Locator" for more information.
F
i
1
2
3
4
5
6