Product Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 General Information
- 2 How to Use the Locator
- 3 How to Use the Transmitter
- 4 How to Use the Conductive Rod
- 5 How to Use the Signal Clamp
- 6 How to Use the Property Connection Set
- 7 How to Use the Sonde
- 8 Care and Transport
- 9 Safety Directions
- 10 Technical Data
- 11 International Limited Warranty
- Appendix A Functional Checks
- Appendix B World Frequency Zones
- Index
60EZiSYSTEM, How to Use the Sonde
Changing to 8 kHz mode:
Once the function of the Sonde has been checked with a Locator set to the same operating
mode it can be attached to drain rods or other means of guiding it into the service being
traced.
1. Unscrew and remove end cap.
Insert battery, positive end first.
Refit end cap securely.
2. Hold Sonde upright.
Confirm green light is continuous.
3. Rotate Sonde so the LED points down and wait approxi-
mately 1 second.
4. Rotate Sonde upright.
Confirm the amber coloured LED is continuous.
If LED remains green repeat from step 1.
5. Wait approximately 10 seconds for the amber LED to start
flashing.
6. With the amber LED flashing, the Sonde is ready for use at
8kHz.