User Manual

Total Station Manual
42
station.
ƹ
Press [On] to open the compensator and press [Off] to close the compensator.
ƹ
Press [X Only] to open the compensator of X direction.
ƹ
Press [
Ʒ
][

] to adjust the laser plummet brightness.
ƹ
Press [OK] to closs the laser plummet and exit.
2. Offset
The Offset is used to measure the points which are not intervisible or intervisible
but can not set up prism in the Station.
Offset contains Dist.Offset and two subprograms, the two subprograms are
Cylinder Offset and Angle Offset.
2.1 Distance Offset
Using the external tools to measure the Offset values of the target point p2 and
measurement point p1 along the line of station point and measurement point,the
Offset values are Trav.OFS, LengthOFS and HeighOFS. Combining the information
of measuring point (p1) can calculate the distance of station point (p0) to target point
(p2), can also calculate the angel and coordinate.
When the measurement point is set on the left of target point or the right of target
point, you should make the angle that between line of measurement point and target
point and the line of measurement and station point about equals 90
e
. When the
offset point is set on the front of target point or on the back of target point, you should
make it on the line of station point and target point.
Steps Key Display