User's Manual

Quick Start Guide Utility Scan 350HS

Set Depth and Focus Data

This will allow you to enter a known depth or migrate the data to re-establish a

dielectric value. Note that two icons at the bottom have changed when the backup

cursor is displayed on the screen (when the cart was pushed backward.

• Set Depth

a) Using the stylus pen, place the horizontal line at a known depth.

b) Tap Set Depth.

c) Input the depth and accept. This will change the dielectric value.

• Focus On

a) Using the stylus pen, place the cross-hair on a hyperbola.

b) Tap on Focus On.

c) Using the stylus pen, match the Focus On hyperbola with a hyperbola on

the screen (width).

d) Tap on:

• Set Focus to accept the hyperbola. This will change the dielectric value.