User's Manual
Table Of Contents
- QF7D50300800 Manual
- Keyboard Capability 2
- ToughBook Information 3
- Standard Icons 4
- Display Channel (Frequency) Icons 4
- Powering and Booting Up 5
- Powering Down 7
- Playback Only Mode 8
- New Project Mode and Last Project Mode 20
- Collecting Data 32
- Limited Warranty, Limitations Of Liability And Restrictions
- Regulatory Information
- Section 1: Getting Started
- Keyboard Capability
- ToughBook Information
- Standard Icons
- Display Channel (Frequency) Icons
- Powering and Booting Up
- Powering Down
- Section 2: Playback Only, New Project, and Last Project Modes
- Playback Only Mode
- New Project Mode and Last Project Mode
- Collecting Data
- Appendix A: Cart and Antenna Assembly Instructions
- Appendix B: Battery Charger Information
- Appendix C: Dielectrics of Common Materials (Soil Conditions)
- Appendix D: Examples of Some Common Objects
- Appendix E: Glossary of Terms
- PageBreak
- Y15198D1 GPR Coordination Notice& Equip Reg
- Canadian Requirements for RSS
- Equipment CE Conformance
Quick Start Guide UtilityScan DF
Copyright © 2012 Geophysical Survey Systems, Inc. 32
All Rights Reserved
Collecting Data
• If you plan to save the data you collect, note the file name located at the top left of the screen.
• Begin collecting data by moving the cart forward. Data gets collected only when the cart is moving forward.
• Once you start seeing hyperbolas on the screen, pull the system straight back along your survey line. You will
see a vertical line (the backup cursor) scroll along your data. When that vertical line is right over the apex of the
hyperbola, the center of the antenna is over that target.
• The center of the antenna is located in the middle of the
antenna directly under the capsule between the two centerline
indicators on each side of the cart. Using these as reference
points, mark the ground at each side of your cart. After
moving the cart, place an “X” between the two marks. Push
the cart straight forward or move the cart to do another line
scan. No data will be collected until you have passed the spot
where you started to reverse.
Hyperbola which represents a target
Vertical Line (Backup Cursor)