User's Manual
Table Of Contents
- QF7D50300800 Manual
- Keyboard Capability 2
- ToughBook Information 3
- Standard Icons 4
- Display Channel (Frequency) Icons 4
- Powering and Booting Up 5
- Powering Down 7
- Playback Only Mode 8
- New Project Mode and Last Project Mode 20
- Collecting Data 32
- Limited Warranty, Limitations Of Liability And Restrictions
- Regulatory Information
- Section 1: Getting Started
- Keyboard Capability
- ToughBook Information
- Standard Icons
- Display Channel (Frequency) Icons
- Powering and Booting Up
- Powering Down
- Section 2: Playback Only, New Project, and Last Project Modes
- Playback Only Mode
- New Project Mode and Last Project Mode
- Collecting Data
- Appendix A: Cart and Antenna Assembly Instructions
- Appendix B: Battery Charger Information
- Appendix C: Dielectrics of Common Materials (Soil Conditions)
- Appendix D: Examples of Some Common Objects
- Appendix E: Glossary of Terms
- PageBreak
- Y15198D1 GPR Coordination Notice& Equip Reg
- Canadian Requirements for RSS
- Equipment CE Conformance
Quick Start Guide UtilityScan DF
Copyright © 2012 Geophysical Survey Systems, Inc. 33
All Rights Reserved
Set Depth and Focus Data
This will allow you to enter a known depth or migrate the data to re-establish a
dielectric value. Note that two icons at the bottom have changed when the backup
cursor is displayed on the screen (when the cart was pushed backward.
• Set Depth
a) Using the stylus pen, place the horizontal line at a known depth.
b) Tap Set Depth.
c) Input the depth and accept. This will change the dielectric value.
• Focus On
a) Using the stylus pen, place the cross-hair on a hyperbola.
b) Tap on Focus On.
c) Using the stylus pen, match the Focus On hyperbola with a hyperbola on
the screen (width).
d) Tap on:
• Set Focus to accept the hyperbola. This will change the dielectric value.
• or Focus Off to cancel this process .