User's Manual
Table Of Contents
- QF7D50300800 Manual
- Keyboard Capability 2
- ToughBook Information 3
- Standard Icons 4
- Display Channel (Frequency) Icons 4
- Powering and Booting Up 5
- Powering Down 7
- Playback Only Mode 8
- New Project Mode and Last Project Mode 20
- Collecting Data 32
- Limited Warranty, Limitations Of Liability And Restrictions
- Regulatory Information
- Section 1: Getting Started
- Keyboard Capability
- ToughBook Information
- Standard Icons
- Display Channel (Frequency) Icons
- Powering and Booting Up
- Powering Down
- Section 2: Playback Only, New Project, and Last Project Modes
- Playback Only Mode
- New Project Mode and Last Project Mode
- Collecting Data
- Appendix A: Cart and Antenna Assembly Instructions
- Appendix B: Battery Charger Information
- Appendix C: Dielectrics of Common Materials (Soil Conditions)
- Appendix D: Examples of Some Common Objects
- Appendix E: Glossary of Terms
- PageBreak
- Y15198D1 GPR Coordination Notice& Equip Reg
- Canadian Requirements for RSS
- Equipment CE Conformance
Quick Start Guide UtilityScan DF
Copyright © 2012 Geophysical Survey Systems, Inc. 5
All Rights Reserved
Powering and Booting Up
1 Assemble the cart as shown in Appendix A: Cart Assembly Instructions.
Important: Antenna battery must be attached to the antenna before continuing to Step 2.
2 To power up the system:
a) Press and hold the power button on the ToughBook for
about 2 seconds until a green light illuminates above the
power button. A green light will blink on the antenna
during the system boot up. It will be off when the boot up
process is complete. This green light will illuminate when
communication is re-established.
b) After a few seconds, when the system boot up is complete,
the UtilityScan DF Start Screen is displayed.
c) Tap either:
• A1 Icon or press the A1 button to start.
• A5 Icon or press the A5 button to update system
software.