User Manual

Geophysical Survey Systems, Inc. HandyScan
User's Guide
MN70-416 5
Data Review
1. Use right/left arrow keys to scroll data.
2. Optimize data display:
• Press Gain until best display of features is achieved. Gain
status is shown at bottom left (Gain can be used during
collection as well).
• Press PRCS, then up/down arrow to change processing
method. PRCS method used is shown
at bottom center.
• Use Set to modify display setup (contrast, amplitude, depth
scale, etc.).
3. Label targets:
• Use arrow keys to move the cursors and locate targets. The
cross-hair X (position) and Y (depth) are displayed in the
top left corner.
• Press Mark to label a target and display its X-Y along the
right edge of screen (up to 7 targets).
Note
:
It is possible to transfer non-grid data to a PC and review
them on the PC screen, taking advantage of a higher quality
display and (if installed) processing capability of RADAN
software. Please see Data Transfer (page 7) and RADAN manual
for instructions on processing.