User's Manual
Table Of Contents
- Front/Top View
- Back View
- Before collecting any data, configure your Mini HR for 2D or 3D data collection by pressingSystem Menu Options
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- The Mini HR will then shut down after calibration and will require a re-startClearing Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Scan Density: Selecting the Scan Density
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collect Menu Options
- Project: Saving Files to a Specific Project
- Depth: Selecting the Depth Where You are Scanning
- Dielectric: Selecting the Approximate Dielectric of the Area You are Scanning
- Auto target: Allowing the Mini HR to Automatically Pick Your Targets
- Display: While Collecting Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors You Want Displayed During Data Collection
- Collecting Data and Marking Your Targets
- Playback Menu Options
- Project: Selecting a Specific Project to Select a Specific File to Playback
- Auto Depth: Automatically Adjusting Depth Scale
- Auto Target: Allowing the Mini HR to Automatically Pick Your Targets
- Auto Gain: Allowing the Mini HR to Automatically Configure the Gain
- Display: While Viewing Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors to Display during Data Collection
- Playing Back the Selected File
- Configuring the StructureScan Mini HR for 3D Collection
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- Calibration: Auto Calibrations for Surface and Brightness
- Clear Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collecting 3D Data
- Collect Menu Options
- Collect: Collect 3D Grid
- Playback: Processing and Drawing the 3D Grid
- Modes
- Laser Information: General
- Laser Information: Specific for the StructureScan Mini HR
- Laser Information: Projected Laser Beam Layout
- Laser Information: Label Placement Diagrams
Limited Warranty, Limitations Of Liability And Restrictions
Geophysical Survey Systems, Inc. hereinafter referred to as GSSI, warrants that for a period of 24 months from the delivery date to the
original purchaser this product will be free from defects in materials and workmanship. EXCEPT FOR THE FOREGOING LIMITED
WARRANTY, GSSI DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. GSSI's obligation is limited to repairing or replacing parts
or equipment which are returned to GSSI, transportation and insurance pre-paid, without alteration or further damage, and which in
GSSI's judgment, were defective or became defective during normal use.
GSSI ASSUMES NO LIABILITY FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR INJURIES CAUSED BY PROPER OR IMPROPER OPERATION OF ITS EQUIPMENT, WHETHER OR NOT
DEFECTIVE.
Before returning any equipment to GSSI, a Return Material Authorization (RMA) number must be obtained. Please call the GSSI
Customer Service Manager who will assign an RMA number. Be sure to have the serial number of the unit available.
Regulatory Information
Please see the GSSI Manual CD or our website, www.geophysical.com/regulatoryinformation.htm, for current information and
FCC Registration Form, including:
• FCC Notice for U.S. Customer
• Canadian Requirements for RSS-220
• Declaration of CE Conformance
Laser Cautions and Warnings
Please see Appendix D for important laser cautions and warnings.