User's Manual
Table Of Contents
- Front/Top View
- Back View
- Before collecting any data, configure your Mini HR for 2D or 3D data collection by pressingSystem Menu Options
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- The Mini HR will then shut down after calibration and will require a re-startClearing Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Scan Density: Selecting the Scan Density
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collect Menu Options
- Project: Saving Files to a Specific Project
- Depth: Selecting the Depth Where You are Scanning
- Dielectric: Selecting the Approximate Dielectric of the Area You are Scanning
- Auto target: Allowing the Mini HR to Automatically Pick Your Targets
- Display: While Collecting Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors You Want Displayed During Data Collection
- Collecting Data and Marking Your Targets
- Playback Menu Options
- Project: Selecting a Specific Project to Select a Specific File to Playback
- Auto Depth: Automatically Adjusting Depth Scale
- Auto Target: Allowing the Mini HR to Automatically Pick Your Targets
- Auto Gain: Allowing the Mini HR to Automatically Configure the Gain
- Display: While Viewing Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors to Display during Data Collection
- Playing Back the Selected File
- Configuring the StructureScan Mini HR for 3D Collection
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- Calibration: Auto Calibrations for Surface and Brightness
- Clear Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collecting 3D Data
- Collect Menu Options
- Collect: Collect 3D Grid
- Playback: Processing and Drawing the 3D Grid
- Modes
- Laser Information: General
- Laser Information: Specific for the StructureScan Mini HR
- Laser Information: Projected Laser Beam Layout
- Laser Information: Label Placement Diagrams
Quick Start Guide StructureScan Mini HR
Geophysical Survey Systems, Inc.
25
2 Press Ï Ð to select the appropriate options:
• Orientation – Press to toggle between Right or Left. This will flip the screen
to allow for either right or left handed operation..
• Language – Press to select your language preference.
• Units – Press to toggle between English or Metric.
• Laser – Press to toggle laser On or Off. If configured On, the laser will light up in
the Collect Menu only. Note: The laser will blink (whether configured On or Off)
when battery life is low (10%).
Caution: Do not stare into beam.
• Sound – Press to toggle between High, Medium, Low, or Off.
• Version(s) – Press to display the version number of the software. Please visit
GSSI’s web site for updates to the firmware.
• Options – Press to configure Scan Density and Migration Type.
• Scan Density – Press
to toggle between Normal and Low.
• Normal – The Mini HR will scan at 8 scans/cm (approximately 240 scans/ft).
• Low – The Mini HR will scan at 4 scans/cm (approximately 120 scans/ft).
• Mig Type – When Migrating the data, whether to use the full samples or half
samples.
• Max – Full number of samples (slower processing, but clearer picture).
• Half – Every other sample (faster processing, but not as clear picture).
• Press Î to return to the previous menu.